How to change batteries in swiffer wet jet? (2024)

Where do the 4 batteries go in a Swiffer Wetjet?

Open the Battery Compartment and Load Batteries

Press down on the lines, and slide the piece upwards, towards the top of the device's handle. The entire battery compartment will separate from the Wetjet's handle. Flip it over, and you'll see a compartment with space for four batteries — two on each side.

Does Swiffer have a warranty?

A One-Year Warranty On Our Swiffer Products

Sit back and relax. Our product warranties provide you with complete satisfaction.

Can you put Pine Sol in a Swiffer wet jet?

My "Swiffer Wet Jet": 1-2 Tbsp. Pine-Sol in a 1 qt. spray bottle of water.

How long does a Swiffer battery last?

It states the vac will run for about 10 - 12 minutes on one charge, then need to be charged for 16 hours.

Why do Swiffers stop working?

If your Wetjet won't spray, it's possible that your batteries have worn down and need to be replaced. That's especially likely if the power of your spray slowly decreased before it stopped altogether, or if your Wetjet has been sitting in a closet for a while.

Does Swiffer Wet Jet take 2 or 4 batteries?

A: It may be helpful to know that as of September 2021, our WetJet now takes 2 AA batteries instead of 4.

Is Swiffer Wet Jet enough?

Plus, it might not be the most effective option, says Amanda Weatherholt, crew leader with Housekeeping Associates of Ann Arbor, Michigan. “The Wet Jet leaves the floor streaky and just moves the dirt around—it does not clean the floor,” she says.

How do I contact Swiffer?

Swiffer Money Back Guarantee Dept. 43577 250-INT006 Pickering, ON L1V 2R4 For any other questions about the Swiffer Money Back Guarantee, contact us at 1-866-411-1753.

Do you throw away Swiffer Wet Jet pads?

Swiffer® WetJet™ Pad Refill

When you're done, just remove the pad and throw it, and all that dirt, away forever.

Are you supposed to flip Swiffer pads?

2) Flip it.

While the grooves allow for more debris to be picked up, the “wrong” side of the pad still has its uses. Once I am done using the pad to clean the floor, I use the reverse side to clean along the top of baseboards, along the spindles and banister on our stairs, or other little areas that need a dusting.

Do you vacuum before or after Swiffer?

1. Don't Swiffer sweep without vacuuming first. The Swiffer Sweeper pads will do a better job picking up dirt on floors when the larger dust bunnies are out of the way, so a quick pick-up or vacuum job beforehand could help your duster pack a mightier punch.

Why is my spray mop not spraying?

Double-check that the mop poles are securely in place, with the white tabs clicked through the metal hole. Otherwise, the trigger won't work. Test the spray trigger. If it doesn't give some resistance check the poles again.

How often should you Swiffer the house?

Sweep often — at least once a week. By sticking to this routine, you can clean your floors before dirt has time to collect on the surface.

How often to replace Swiffer wet jet?

Replace the WetJet pads after every use.

Put a new pad onto the bottom of your Swiffer so that it's all set to go next time you need to mop your floors.

What to do when you run out of Swiffer pads?

If you run out of dry Swiffer pads, you can use a fuzzy sock as an alternative in a pinch. Just stretch the sock over the mop head, and the fabric will work similarly to a regular pad, attracting dust and hair using its static charge.

Why is my mop water still dirty after mopping?

Avoid Using Too Much Soap

Soap only lifts dirt and oil into water, making them suspend in water. Therefore, the more soap you use, the more your mop gets saturated with dirt. So, if you do not remove all the soapy water from the floor, the dirt remains, forming streaks on the floor.

Can I soak my mop in vinegar?

Any mop can start to smell after frequent use. To get rid of the odour, add one cup of white vinegar to one gallon of hot water and allow it to soak for a few minutes. After soaking, continue with the cleaning process for a regular wet mop.

Why is my floor still sticky after mopping?

Since regular floor cleaners can also leave your floors sticky, warm water is a great way to remove any excess cleaner and leave your floor free of stickiness. All you need to do is mop the floor with warm to hot water, depending on how grimy the surface is (be careful not to burn yourself!).

Can you put Murphy Oil Soap in Swiffer WetJet?

Add 2 tablespoons of Murphy Oil Soap to the water and stir to combine. Insert a funnel into an empty Swiffer Solution bottle and pour in your homemade solution. Or, you can dip the Swiffer mop head directly into the solution and mop your floor as normal.

What liquid do you put in a Swiffer WetJet?

Can you use dry wipes on Swiffer WetJet?

A: yes, but only if you do not use the spray solution on the wet jet. You can attach these dry swiffer cloths to the wet jet stick and use them to dry wipe the floor, but they are not compatible with the wet solution and are not made to mop the floor.

Can you clean windows with Swiffer?

It's quick, easy, and it would work for windows, too. The best part is that all it requires is stuff you probably have at home already. Specifically, a Swiffer Sweeper, glass cleaner, and a microfiber cloth.

Is Swiffer Wet Jet OK for hardwood floors?

Q4: Is the Swiffer WetJet ok for a hardwood floor? Ans: For households with a variety of floor surfaces, the Swiffer WetJet is perfect. Almost any type of floor can be cleaned with this solution, including hardwood.

Why is my Swiffer not charging?

Battery will not recharge

Turn off the Swiffer. The Swiffer cannot recharge if it is on. If after 12 hours of charging the battery is still incapable of powering the device, it will most likely need a replacement unit. A new battery can be purchased via this link: Purchase new battery.

What is the red light on the Swiffer?

2 Answers. a red light will illuminate to show it's charging and then turns green to indicate it's fully charged.