Swiffer wetjet not working after changing batteries? (2024)

Swiffer wetjet not working after changing batteries?

However, if you have changed the batteries and still do not hear the motor running, the pump motor may be clogged, rusty and needs to be lubricated.

Why is my spray mop not spraying?

Double-check that the mop poles are securely in place, with the white tabs clicked through the metal hole. Otherwise, the trigger won't work. Test the spray trigger. If it doesn't give some resistance check the poles again.

Why is my Swiffer vac not turning on?

The most likely reason your SweeperVac will not turn on is because the battery is dead. Charge the battery with the provided charger for 12-18 hours or until green indicator light is on to ensure there is sufficient battery life.

Can I use water and vinegar in a Swiffer wet jet?

DIY Homemade Swiffer WetJet Solution #3

Mix equal parts hot water and vinegar in a bucket or pitcher (a cup or two of each will work.) Dump in a splash of rubbing alcohol to keep anything gross from growing in the Swiffer refill container. As an option, add a couple drops of essential oil.

Does Swiffer have a warranty?

A One-Year Warranty On Our Swiffer Products

Sit back and relax. Our product warranties provide you with complete satisfaction.

Do you have to vacuum before using a Swiffer WetJet?

Don't Swiffer sweep without vacuuming first

The Swiffer Sweeper pads will do a better job picking up dirt on floors when the larger dust bunnies are out of the way, so a quick pick-up or vacuum job beforehand could help your duster pack a mightier punch.

Where do the 4 batteries go in a Swiffer Wetjet?

Open the Battery Compartment and Load Batteries

Press down on the lines, and slide the piece upwards, towards the top of the device's handle. The entire battery compartment will separate from the Wetjet's handle. Flip it over, and you'll see a compartment with space for four batteries — two on each side.

How often to replace Swiffer Wetjet?

Replace the WetJet pads after every use.

Put a new pad onto the bottom of your Swiffer so that it's all set to go next time you need to mop your floors.

What to do if spray doesn t work?

Use Warm Water. If you think your spray bottle has a clog, Poepping says to take the top off and place the tubing (with the nozzle still attached) in a cup of hot water; pump the spray top until water sprays out with ease. Once you're satisfied with the mechanism, place the top back onto the bottle and continue using.

Can I put vinegar in my spray mop?

Homemade Spray Mop Solution

Many homemade floor cleaners include white vinegar. Vinegar is a great natural disinfectant and won't leave any sticky residue on your floor. What is this? Add 1/2 cup white vinegar to a gallon of warm water and add to your spray mop as needed.

How long does Swiffer vac battery last?

It states the vac will run for about 10 - 12 minutes on one charge, then need to be charged for 16 hours.

How long does it take the Swiffer to charge?

How do you take apart a Swiffer?

Can I put Pine Sol in my Swiffer wet jet?

My "Swiffer Wet Jet": 1-2 Tbsp. Pine-Sol in a 1 qt. spray bottle of water. Spray floor as you mop!

Can you use dish soap in a Swiffer?

Add equal parts of water and distilled vinegar until almost full. Squeeze just a couple of drops (DROPS!) of dish soap into the bottle. Replace cap.

Why is my mop water still dirty after mopping?

Avoid Using Too Much Soap

Soap only lifts dirt and oil into water, making them suspend in water. Therefore, the more soap you use, the more your mop gets saturated with dirt. So, if you do not remove all the soapy water from the floor, the dirt remains, forming streaks on the floor.

How long to soak mop in vinegar?

If you add some white vinegar into the bucket of water, it will help to remove any grease or oils from your mop. Then, soak your mop in the vinegar solution for 5 minutes. Finally, rinse the mop head until the water is clear.

Why is my floor still sticky after mopping?

If you're working with low-quality cleaning equipment, it might be the cause of your sticky floors. Mops that don't properly absorb water and cleaner are common and, in cases of sticky flooring, can often be the cause. If you're still using that decades-old mop, consider switching it out.

Do you throw away Swiffer Wet Jet pads?

Swiffer® WetJet™ Pad Refill

When you're done, just remove the pad and throw it, and all that dirt, away forever.

Has Swiffer been discontinued?

A spokeswoman for P&G says: “The Swiffer brand is not being discontinued.

How often should you Swiffer the house?

Sweep often — at least once a week. By sticking to this routine, you can clean your floors before dirt has time to collect on the surface.

How do I contact Swiffer?

Swiffer Money Back Guarantee Dept. 43577 250-INT006 Pickering, ON L1V 2R4 For any other questions about the Swiffer Money Back Guarantee, contact us at 1-866-411-1753.

Is mopping better than Swiffer?

Overall, microfiber mops have more pros than Swiffer mops. Microfiber mops can be used as a two-in-one to both sweep and mop at the same time. However, a Swiffer mop can typically only clean after the sweeping has already been done.

Can you use a Swiffer Wet Jet Dry?

You can attach these dry swiffer cloths to the wet jet stick and use them to dry wipe the floor, but they are not compatible with the wet solution and are not made to mop the floor. You need to use the swiffer wet jet cloths or just a rag with the mopping solution.

Are wet Swiffers bad for hardwood floors?

According to the manufacturer's website, the Swiffer mop is appropriate for use on finished hardwood floors when you use either the dry or wet refill cloths. Wet refills aren't recommended for use on unfinished, waxed or oiled floors, and you should use them with caution on finished hardwood.